Torte's 3D printer wiki

Klipper screen firmware location: (no permanent link given by Sovol)

• browse to: https://sovol3d.com
• menu: “3D Printer” → “Sovol SV06 Plus”
• scroll down to “Select addons”
• select “Sovol Klipper Screen”
• scroll down to “Sovol SV06 Plus Klipper Screen Firmware”
  ( currently points to https://drive.google.com/drive/folders/1vpKWQXOMGV58dYcx2wK9wJC0HJNqU8tg?usp=sharing )

• Firmware file has to be renamed for each(!) update (*1)
• Use a card smaller than 32GB but bigger than 2GB (*2)
• Format only as “FAT32” (do NOT use “exFAT” or “NTFS”)
• Set the sector size to 4096 source
• Have no other files or directories on that card

*1: It only gets installed, if the filename differs from the one, which was used for the current installation.
*2: Smaller than 2GB does not support 4096byte sectors, larger than 32GB does not support FAT32. If your card is bigger, create a partition which is smaller than 32GB.