{{page>redirect#this_wiki_has_moved}}
https://torte71.github.io/InsideSovolKlipperScreen/orca_profiles.html
{{page>redirect#section}}
----

===== Slicing / Design =====
==== Orca profiles ====
=== joescalon SV06+ profile+buildplate ===
  * https://www.printables.com/de/model/508400-sv06-plus-profiles-and-build-plate/files  {{anchor:joescalon_sv06}}
=== my (based on joescalon) ===
  * {{ :wiki:tm_sv06_klipper_profiles.orca_printer.zip |}}  {{anchor:my}}
  * Modified [[https://www.printables.com/model/1106765-sv06-bed-texture|buildplate texture]] (adjusted positions/sizes of imprints, added imprinted lines)

----

=== joescalon SV07+ profile+buildplate ===
  * https://www.printables.com/de/model/575394-sv07-plus-slicer-additions  {{anchor:cv_profiles}}
=== Christian Vicks profiles ===
  * https://www.printables.com/de/model/607280-cvs-orcaslicer-presets-for-sovol-sv07-plus-v13b1  {{anchor:cv_profiles}}

----

=== Automatic z-offset adjustment per filament ===
Some filaments (like PLA, or some transparent PETG) require a lower z-offset for good bed adhesion than others.\\ Adjusting the z-offset e.g. by -0.05mm can be achieved by by adding ''SET_GCODE_OFFSET Z=-0.05'' to the slicer's filament start code and resetting it in the filament end code (add ''SET_GCODE_OFFSET Z=0.0'' there).\\ The filament start end end codes can be found in Orca's material settings window under the "Advanced" tab.

That offset should be reset in your ''printer.cfg'' as well (to ensure it is reset e.g. after a cancelled print). Add ''SET_GCODE_OFFSET Z=0.0'' to the end of the sections ''[gcode_macro CANCEL_PRINT]'' and ''[gcode_macro END_PRINT]''.

Summarized:
  * Add ''SET_GCODE_OFFSET Z=-0.05'' to slicers filament start code
  * Add ''SET_GCODE_OFFSET Z=0.0'' to
    * slicers filament end code
    * printer.cfg section ''[gcode_macro CANCEL_PRINT]''
    * printer.cfg section ''[gcode_macro END_PRINT]''

----
Back to [[start]]