{{page>redirect#this_wiki_has_moved}}
https://torte71.github.io/InsideSovolKlipperScreen/firmware.html
{{page>redirect#section}}
----

===== Sovol SV06+/SV07+ (mostly) =====
==== Firmware ====
{{anchor:where_to_download}}
=== Where to download ===
Klipper screen firmware location: (no permanent link given by Sovol)
  * browse to: https://sovol3d.com
  * menu: "3D Printer" -> "Sovol SV06 Plus"
  * scroll down to "Select addons"
  * select "Sovol Klipper Screen"
  * scroll down to "Sovol SV06 Plus Klipper Screen Firmware"\\ ( currently points to https://drive.google.com/drive/folders/1vpKWQXOMGV58dYcx2wK9wJC0HJNqU8tg?usp=sharing )

{{anchor:sdcard_not_accepted:}}
=== SD-card not accepted ===
  * Firmware file has to be renamed for each(!) update (*1)
  * Use a card smaller than 32GB but bigger than 2GB (*2)
  * Format only as "FAT32" (do NOT use "exFAT" or "NTFS")
  * Set the sector size to 4096
  * Have no other files or directories on that card

*1: It only gets installed, if the filename differs from the one, which was used for the current installation.\\
*2: Smaller than 2GB does not support 4096byte sectors, larger than 32GB does not support FAT32. If your card is bigger, create a partition which is smaller than 32GB.

Some info about SD-cards taken from [[https://forum.sovol3d.com/t/sv06-mainboard-brick-after-updating-sovol-firmware/862/68|here]].