Differences

This shows you the differences between two versions of the page.

--- sovol_mods [2024/03/14 15:32] – torte
+++ sovol_mods [2025/01/21 12:21] (current) – torte
@@ Line 1: / Line 1: @@
-===== Sovol KlipperScreen =====
+{{page>redirect#this_wiki_has_moved}}
+https://torte71.github.io/InsideSovolKlipperScreen/sovol_mods.html
+{{page>redirect#section}}
+----
+===== Sovol KlipperScreen (Makerbase MKS KLIPAD50) =====
 Please note that this is just work-in-progress.\\
-The changes listed here are not complete and the services below will probably need more work to function.\\
+The changes listed here may not be complete and are just quickly tested.\\
 Thanks to Vasyl Gontar for his additions/corrections to this list.
@@ Line 161: / Line 166: @@
   * Probably useless, works fine without
 === makerbase-wlan0.service ===
-  * **configures wifi**
+  * **configures wpa_supplicant**
   * Files: [[makerbase-wlan0-files]]
   * Unofficial package: {{ :wiki:makerbase-wlan0-service.deb |}}
   * Probably useless, works fine without
 ----
-==== Reverting ====
 === power loss recovery (plr) ===
+  * **resumes print after power failure**
+  * origin: https://github.com/The--Captain/plr-klipper
   * Used files:
     * {{ wiki:plr.cfg|~/printer_data/config/plr.cfg }}
     * {{ wiki:plr.sh|~/plr.sh }}
     * {{ wiki:clear_plr.sh|~/clear_plr.sh }}
+  * Unofficial package: {{ :wiki:plr-klipper.deb |}}
+  * Included in Sovol's default printer.cfg, thus it's recommended
+----
+==== Reverting ====
+=== power loss recovery (plr) ===
-++++remove power loss recovery |
     - Make a backup of printer.cfg!
     - Edit printer.cfg, find and remove the 3 paragraphs shown below.
@@ Line 211: / Line 221: @@
 </code>
-++++
+----
+Back to [[start]]