Differences

This shows you the differences between two versions of the page.

--- orca_profiles [2024/02/16 09:42] – created torte
+++ orca_profiles [2025/01/21 12:17] (current) – torte
@@ Line 1: / Line 1: @@
+{{page>redirect#this_wiki_has_moved}}
+https://torte71.github.io/InsideSovolKlipperScreen/orca_profiles.html
+{{page>redirect#section}}
+----
 ===== Slicing / Design =====
 ==== Orca profiles ====
 === joescalon SV06+ profile+buildplate ===
-* https://www.printables.com/de/model/508400-sv06-plus-profiles-and-build-plate/files  {{anchor:joescalon_sv06}}
+  * https://www.printables.com/de/model/508400-sv06-plus-profiles-and-build-plate/files  {{anchor:joescalon_sv06}}
 === my (based on joescalon) ===
-* xxx {{anchor:my}}
+  * {{ :wiki:tm_sv06_klipper_profiles.orca_printer.zip |}}  {{anchor:my}}
+  * Modified [[https://www.printables.com/model/1106765-sv06-bed-texture|buildplate texture]] (adjusted positions/sizes of imprints, added imprinted lines)
 ----
 === joescalon SV07+ profile+buildplate ===
-* https://www.printables.com/de/model/575394-sv07-plus-slicer-additions  {{anchor:cv_profiles}}
+  * https://www.printables.com/de/model/575394-sv07-plus-slicer-additions  {{anchor:cv_profiles}}
 === Christian Vicks profiles ===
-* https://www.printables.com/de/model/607280-cvs-orcaslicer-presets-for-sovol-sv07-plus-v13b1  {{anchor:cv_profiles}}
+  * https://www.printables.com/de/model/607280-cvs-orcaslicer-presets-for-sovol-sv07-plus-v13b1  {{anchor:cv_profiles}}
+----
+=== Automatic z-offset adjustment per filament ===
+Some filaments (like PLA, or some transparent PETG) require a lower z-offset for good bed adhesion than others.\\ Adjusting the z-offset e.g. by -0.05mm can be achieved by by adding ''SET_GCODE_OFFSET Z=-0.05'' to the slicer's filament start code and resetting it in the filament end code (add ''SET_GCODE_OFFSET Z=0.0'' there).\\ The filament start end end codes can be found in Orca's material settings window under the "Advanced" tab.
+That offset should be reset in your ''printer.cfg'' as well (to ensure it is reset e.g. after a cancelled print). Add ''SET_GCODE_OFFSET Z=0.0'' to the end of the sections ''[gcode_macro CANCEL_PRINT]'' and ''[gcode_macro END_PRINT]''.
+Summarized:
+  * Add ''SET_GCODE_OFFSET Z=-0.05'' to slicers filament start code
+  * Add ''SET_GCODE_OFFSET Z=0.0'' to
+    * slicers filament end code
+    * printer.cfg section ''[gcode_macro CANCEL_PRINT]''
+    * printer.cfg section ''[gcode_macro END_PRINT]''
+----
+Back to [[start]]